Curtis FP-6 Style Throttle – 0-5K Ohm

Description

Ideal for tough environments such as material handling. Curtis style foot pedals are used with Curtis electronic motor speed controllers, as well as models by other manufacturers. Designed for maximum installation flexibility and durability. These pedals are made of rugged aluminum castings.

• 0-5k ohm 2-Wire or 5k-0 ohm 3-Wire throttle
• One microswitch
• 3 ft + long, 7-wire unshielded cable
• Adjustable spring-return on pedal, ~1.75″ travel
• Metal shaft with aluminum housing and rubber gaskets
• Foot surface is ribbed aluminum with natural finish

Current – Wiring:

For a 0-5K Ohm 2-Wire setup, use the Brown & Black wires.
Foot switch would use Blue and Green/Yellow.

Gray – is the high side of the pot
Brown – is the wiper
Black –  is the low side of the pot
For 5K-0 2-Wire, use Gray and Brown

Older models Wiring:

For a 0-5K Ohm 2-Wire setup, use the Brown (1) & Black (2) wires for the throttle and Blue (4) and Yellow (5) for the foot switch.

Red / Gray (3) is the high side of the pot
Brown (1) is the wiper
Black (2) is the low side of the pot
For 5K-0 2 wire, use Red / Gray (3) and Brown (1)